AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Zigbee Packet Sniffer Software4/25/2021
You cant really control the network configuration but it helps to see the relationship between your nodes if your troubleshooting a connection problem.The SmartThings hub is the red C (coordinator) and the other devices with an R are ZigBee routers and E are ZigBee end nodes.If I log into my SmartThings IDE and look at my devices under the Zigbee Id column I can lookup each devices ZigBee address.For example the end node device 000D6F00032A0F17 is my SmartSense OpenClosed sensor, and I can see it is connected directly to the SmartThings hub with good signal strength.
![]() You can not see the ZigBee traffic between your nodes it simply maps out the routing table held by each ZigBee device on your network. Protocol analyzers are expensive and give you massive amounts of information that is really only useful to a device engineer or low level programmer. There is a fair chance a lot of your devices are Z-Wave so dont expect it to map those devices. Zigbee Packet Sniffer Software Windows 7 But IIn my case Im using Windows 7 but I think it will work on 10. You need to buy a Digi USB dongle and download and install the XCTU application. The USB dongle will be sent to you with a generic configuration and the SmartThings hub will not allow it to join the network. It must be configured with the proper security settings and the correct trust center link key for the ZigBee Home Automation profile. Once the USB dongle has the correct configuration the SmartThings hub will allow it to join as a thing. Open the XCTU program and click on the scan icon to find your USB dongle. Zigbee Packet Sniffer Software Download The XMLDownload the XML configuration file form my CoopBoss.com web site and copy it to your local hard drive. Now click on Load configuration file (the little down arrow by the person icon) and write it to your USB dongle by clicking on the pencil icon. At this point your USB dongle is looking for a valid ZigBee home automation network to join and you can see the status of this quest by scrolling down to the Diagnostic Commands and look at the AI (Association Indication) parameter. You should see a 21 or 23 or FF they all basically say it is looking for a network to join. When it reads 0 you have joined a valid ZigBee network and can start mapping out the nodes. Does anyone know if we can re-route a path manually instead of letting the network heal it self Would that be possible through this software. A Source routed packet includes the entire route the packet should traverse to get from source to destination. This is usually for very special use cases and the change has to be made in the firmware of the device. The XCTU program is pretty passive it just reads the routing tables of the ZigBee routers. It periodically broadcast a packet that triggers all ZigBee routers to update their routing table with the most efficient route to the hub. This insures all ZigBee routers have a fresh accurate route to the hub.
0 Comments
Read More
Leave a Reply. |